Skip to content
  • Who we are
  • The Lab
  • products
  • contact us
Menu
  • Who we are
  • The Lab
  • products
  • contact us
Read more about the article CNC calibration with Nomad883

CNC calibration with Nomad883

  • Post author:oseyeris
  • Post published:September 11, 2021
  • Post category:Uncategorized

recently bought a threaded table from Carbide3d but it has introduced offset and calibration issues into the product I’ve been making. This is primarily because the product I’m making requires…

Continue ReadingCNC calibration with Nomad883

Designing the venturi cnc

  • Post author:oseyeris
  • Post published:April 27, 2021
  • Post category:Uncategorized

We have a pretty large compressor that has a readout for the pressure

Continue ReadingDesigning the venturi cnc

Running Epoxy Tests for strength testing the Flipout to insert

  • Post author:oseyeris
  • Post published:March 29, 2021
  • Post category:Uncategorized

I recently changed the design to have a ridge in it that may allow for more spread surface area, so when glue is applied to both sides, the Delrin is…

Continue ReadingRunning Epoxy Tests for strength testing the Flipout to insert

More code additions for bCNC – Running headless

  • Post author:oseyeris
  • Post published:March 9, 2021
  • Post category:Uncategorized

To run remotely, there's the option to forward Application windows to the host computer, however when thinking about automation, it might be best to make sure that the programs can…

Continue ReadingMore code additions for bCNC – Running headless

Musings on the CNC usage and automation

  • Post author:oseyeris
  • Post published:March 3, 2021
  • Post category:Uncategorized

We might still be able to use sams robot to load and take away blocks from the cnc machine. The only reason we're using a 1.2kg block of delrin per…

Continue ReadingMusings on the CNC usage and automation

Fixing the Macaron low power mode. WIP

  • Post author:oseyeris
  • Post published:February 28, 2021
  • Post category:Uncategorized

I had previously been using a 3.3V linear voltage regulator to regulate the battery for the circuits on the Macaron board. Because of the wide voltage range, 2.8 at low…

Continue ReadingFixing the Macaron low power mode. WIP

Code to add to bCNC for tooltip measurement functionality

  • Post author:oseyeris
  • Post published:February 23, 2021
  • Post category:Uncategorized

The Basic premise of this code is that you store 2 items and on boot sequence, you're able to re-measure the tooltip and adjust for the difference with the existing…

Continue ReadingCode to add to bCNC for tooltip measurement functionality

Recent Posts

  • Protected: Working on the Flash Template
  • CNC calibration with Nomad883
  • Designing the venturi cnc
  • Running Epoxy Tests for strength testing the Flipout to insert
  • More code additions for bCNC – Running headless

Recent Comments

    Copyright - OceanWP Theme by Nick